United Kingdom
Print this page
Tel:
+44 (0)1963 362640
Fax:
+44 (0)1963 363762
Email:
sales@adbruf.com

Void Filler - Fills Voids and cracks, Sealer, Grout and Surface Regulator

Void and Crack Filler
Void Filler - Fills Voids and cracks, Sealer, Grout and Surface Regulator
Roll over an image below to enlarge
Void Filler - Fills Voids and cracks, Sealer, Grout and Surface Regulator
Void Filler - Fills Voids and cracks, Sealer, Grout and Surface Regulator
Void Filler - Fills Voids and cracks, Sealer, Grout and Surface Regulator
Void Filler - Fills Voids and cracks, Sealer, Grout and Surface Regulator
Product Benefits
Common Uses
  • Sold in 25kg packs
  • Regulates and standardises the substrate onto which resin bonded surfacing is to be applied
  • Binds and seals open-textured substrates
  • Can be used to smooth, rough tamped concrete and textured asphalt
  • Strong - 30N/mm² can be achieved when fully cured
  • Rapid curing materials are available
  • Cost-effective
  • Suitable for asphalt, macadam and concrete surfaces and substrates
  • Supplied in kit form - no guesswork over quantities to be dosed
  • Excellent adhesion to most prepared surfaces

All commonly encountered surfaces and substrates such as asphalt and concrete. These substrates are often not smooth which is referred to as having a surface texture. The degree of surface texture can be measured as 'texture depth' using the standard sand patch test.

By using Void Filler to bring the surface level, not only will it enable the resin bonded system to be correctly installed with good adhesion, but the cost will be predictable and controllable.

Product Description

collapse

Void Filler is cement based crack filling system that is used to regulate an uneven substrate in preparation for the application of a resin bonded paving system. It has been produced to be strong, have good adhesion and be easy to apply to most commonly encountered surfaces.

Customer Reviews

collapse

Be the first to comment on this article


Leave a review

Name
Email (Not displayed on site)
Location
Rating RatingRatingRatingRatingRating

Review
A resin bound surfacing system forms a a layer between 12 - 25mm thick dependent on the end use of the surface. http://t.co/YS0Lf...